![brocade san switch commands brocade san switch commands](https://support.purestorage.com/@api/deki/files/1579/original.jpeg)
When a virtual machine has a WWN assigned to it, the virtual machine's configuration file(.vmx) is updated to include a WWN Mode 3 is preferable to modes 1 and 2 as it captures more cases.
#Brocade san switch commands software
If the attempt fails to go into active state, this command executes software idle-arb (mode 2).
![brocade san switch commands brocade san switch commands](https://exchangeengine.files.wordpress.com/2011/05/cfgshow.png)
Note For FOS 6.3.0 there are two options when using portcfgfillword CLI command:Ġ | -idle-idle Sets IDLE mode in the Link Init and IDLE as the fill word (default).ġ | -arbff-arbff Sets ARB(ff) in the Link Init and ARB(ff) as the fill word.Īt FOS 6.3.1 there are now the following three options when using the portcfgfillword CLI command:Ģ | -idlef-arbff Sets IDLE mode in the Link Init and ARB(ff) as the fill word.ģ | -aa-then-ia Attempts hardware arbff-arbff (mode 1) first.
![brocade san switch commands brocade san switch commands](http://1.bp.blogspot.com/-T260hyniFRk/T2tHERkaVjI/AAAAAAAAABw/-SsiwgYw2cw/s1600/Picture5.png)
This problem occurred on 8 Gb Brocade switches. The CLI command to change the fill word is: The CLI command to check the fill word setting is: The EMC preferred idle mode is 3, ARB(ff)/ARB(ff) then IDLE/ARB(ff). The link does come up when the fill word is switched back to IDLE. Once changed to ARB(FF), the link does not initialize when connected to a CLARiiON port. The fill word can be changed to ARB(FF) using a CLI command. Slower link speeds only use the IDLE fill word and do not have this issue.įix The Brocade 8 Gb-capable switches have the default fill words set to IDLE. This change uses the ARB(FF) primitive signal in place of IDLE as a fill word to maintain link synchronization.ĭuring link initialization, 6 IDLE frames are sent before sending ARB(FF) at port state LR3. The default fill word was changed from IDLE to ARB(FF) to comply with T11 standards.Ĭause The T11 fiber committee changed the FC-PI-3 standard for 8 Gb attachment on February 4, 2008. Symptom In the output of the switchshow command from the Brocade switch we see that the port that the CX / VNX Storage port is failing to log into changes to port type = L-port.Ĭhange An 8 Gb capable Brocade switch was installed. Symptom CLARiiON 8Gb/s port does not synchronize to Brocade switch port when ARB(FF) fill word is used. #zonecreate "zone name","zone member1 member2" #zoneobjectrename "old name","new name" // ZONENAME 변경
![brocade san switch commands brocade san switch commands](http://pyatilistnik.org/wp-content/uploads/2016/05/brocade-fc-300.png)
#ipfilter -addrule Blockport -rule 1 -sip any -dp 111 -proto tcp -act deny #ipfilter -clone Blockport -from default_ipv4